Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
TECHNICAL DATA
TRH25
CAPACITY
OVERALL WIDTH
DISTANCE BETWEEN FORKS
FORKS WIDTH
FORKS LENGTH
TOTAL HEIGHT
STRUCTURE HEIGHT
MINIMUM LIFTING HEIGHT
MAXIMUM LIFTING HEIGHT
WHEEL DIAMETER
ROLLERS DIAMETER
TRH3
CAPACITY
OVERALL WDITH
DISTANCE BETWEEN FORKS
FORKS WIDTH
FORKS LENGTH
TOTAL HEIGHT
STRUCTURE HEIGHT
MINIMUM LIFTING HEIGHT
MAXIMUM LIFTING HEIGHT
WHEEL DIAMETER
ROLLERS DIAMETER
OPERATION INSTRUCTIONS
ATTACHING DRAW-BAR TO PUMP UNIT
If you have purchased a wooden box of pallet
truck, some assembly is required. Certainly, you
need some tools, a hammer, a pliers, a spanner,
etc; and some parts, one axle with hole , two
elastic pins (Note one is in the axle ), these parts
are putted in a plastic bag, which is putted into
the draw-bar.
NOTE: The number of draw-bar and pump
should be the same.
8
5 512 lb
21-1/4"
8-11/16"
6-5/16"
45-1/4"
48-7/16"
17-1/2"
3"
7-1/2"
7"
3"
6 613 lb
21-15/16"
14-3/8"
6-9/32"
48"
51-15/16"
17-1/2"
3"
7-1/2"
7"
3"
Fig.1
1. Draw-bar
2. Pin
3. Axle with hole
4. Elastic pin
5. Fork frame
When attaching the handle, you had better
squat just behind the pallet truck. Then you:
1. Insert the draw-bar into the pump piston,
then use a hammer to insert the axle with
hole into the hydraulic pump and draw-bar
from the right to
left. (See fig. 2 ).
2. Let control handle
to
the
'LOWER'
position, then pass
the adjusting nut,
adjusting bolt and
chain through the hole of axle with your
hand (See fig. 3).
3. Press the draw-bar) down, take away the
pin(#2) (See Fig. 1).
4. Let the control handle on 'RAISE' position,
then raise the lever plate with the pin (#2)
and insert the adjusting bolt(103) into the
front slot of lever plate , note to keep the
adjusting nut on the under side of the lever
plate.
5. Use a hammer to tap another elastic pin into
the axle with hole. The draw-bar is now as-
sembled to the pump.
ADJUSTING RELEASE DEVICE
On the draw-bar of this pallet truck, you can
find the control handle which can be adjusted
in three positions:
1.
Raise: handle down
2.
Drive: handle in center position
3.
Lower: handle up, the lever moves back
the drive position when released.
Fig.2
Fig.3
