Others; Troubleshooting/Repair - Nikon PROSTAFF 3 Manual De Instrucciones

Others

En
Fr
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
Es
(2) This device must accept any interference received, including interference that may cause undesired operation.
Pt
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Do not use the PROSTAFF 3 for purposes beyond the limits of its stated accuracy.
16

Troubleshooting/Repair

If your PROSTAFF 3 should require repair, please contact your local dealer for details regarding where to send
it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom
Unit does not turn on — LCD fails to • Depress POWER button.
illuminate • Check and replace batteries if necessary.
• Be sure that nothing, such as your hand or finger, is blocking
the laser emission aperture and laser detector.
• Be sure that the laser emission aperture and laser detector are
Target range cannot be obtained clean. Clean them if necessary.
• Be sure that the target shape and condition is appropriate to
reflect the laser beam.
• Replace battery.
• Be sure to hold the unit steady while depressing the POWER
button.
[- - -] ("Cannot measure") appears
• Be sure the target is within measuring range (10 - 500m/11 -
550 yards)
• Be sure that nothing, such as leaves or grass, is between the
Closer target cannot be measured
PROSTAFF 3 and the target.
Target beyond a certain distance • Be sure that nothing, such as leaves or grass, is between the
cannot be measured PROSTAFF 3 and the target.
En
Fr
Es
Pt
Check Points
17