Makita BO6040 Manual De Instrucciones página 6

Makita offers an extensive range of optional super soft,
soft and hard pads. Remove the screw counterclockwise
from the center of the base with a hex wrench. After
changing the pad, tighten the screw clockwise securely.
Dust collection (optional accessory)
3
1 2
003328
If a Makita hose is used, you can connect the cuff to the
dust outlet directly.
If other hose with an inner diameter of 24 mm (15/16"),
attach the joint between the dust outlet and the cuff.
1
003329
OPERATION
Sanding operation
003338
CAUTION:
Never switch on the tool when it is in contact with
•
the workpiece, it may cause an injury to operator.
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
All manuals and user guides at all-guides.com
Polishing operation
1. Dust outlet
2. Cuff
3. Hose
Applying wax
1. Joint
003340
Use an optional sponge pad. Apply wax to the sponge
pad or work surface. Run the tool to smooth out wax.
NOTE:
Removing wax
003342
Use an optional felt pad. Run the tool to remove wax.
Polishing
003344
Use an optional wool pad. Run the tool and apply the
wool pad gently to the work surface.
6
CAUTION:
Use only a Makita genuine sponge pad, felt pad or
•
wool pad (optional accessories).
Always operate the tool at low speed to prevent
•
work surfaces from damage/burning.
Never force the tool. Excessive pressure may
•
decrease the polishing efficiency and cause motor
overload, resulting in tool malfunction.
1
First, wax a non critical portion of the work surface
•
to make sure that the tool will not scratch the
surface or result in uneven waxing.
1
1
1. Sponge pad
1. Felt pad
1. Wool pad