Idiomas disponibles
Idiomas disponibles
BELT CLIP
Fix the belt clip to either side of tool by screw.
Make sure the belt clip is firmly installed so
that it can support the weight of the tool.
BIT
WARNING:
Observe the technical requirements of this
product (see section "SPECIFICATIONS") when
purchasing and using bit. Always use special
bits according to the work to be performed.
The chuck and the bit can be very hot after
working, do not assemble/disassemble them
before cooling down.
To install:
Turn the chuck clockwise to open the jaw.
Align and insert the bit as far as into the jaw.
Then turn the chuck counterclockwise so that
the jaw bites the bit fixedly.
WWW.SENIXTOOLS.COM
To remove:
Turn the chuck counterclockwise to open the
jaw and pull the bit out of the jaw.
NOTE:
Make sure the bit is fixed firmly and will never
comes out before use.
BATTERY PACK
NOTE:
Prior to installation, lock the switch trigger by
trigger lock to avoid unintentional start.
To install:
Align and slide the battery pack to the docking
port until it is locked in place.
To remove:
Press the unlock button on battery pack and
slide the battery pack out.
OPERATION
9 - EN
