Idiomas disponibles
Idiomas disponibles
SPEED
Mode
Settinge
Low
1
High
2
The tool reaches its highest speed when the
selector is set to the "2" setting.
WARNING:
Only press the speed selector when the power
tool is completely stop.
SWITCHING ON/OFF
1.
Press the switch trigger to start power tool.
The tool stops when the trigger is released.
2.
Apply more pressure to the trigger leads
to a faster spindle running under current
speed setting.
3.
The work light which helps for the visibility
near the bit automatically turns on when
the trigger is pulled and turns off a few
seconds after the tool stops.
WWW.SENIXTOOLS.COM
Max Speed
0-600 RPM
0-2,000 RPM
HOW TO CHARGE THE
BATTERY PACK
WARNING:
This Lithium-Ion battery pack is shipped
partially charged. Fully charge the battery
pack before using it for the first time.
NOTE:
Charge the battery at an ambient temperature
range of 32°F - 104°F (0°C - 40°C).
1. Charge the Lithium-Ion battery pack only
with the correct charger.
2. Connect the charger to a power supply, the
light indicator of the charger turns red.
3. Align the raised ribs of the battery pack
with the slot in the charger.
4. Insert the battery pack into the charger, the
light indicator of the charger turns green
and it flashes.
5. The charger will communicate with the
battery pack to evaluate the condition of
the battery pack.
6. It is fully charged that the four lights of
the battery turn on. Disconnect the power
supply from the charger. Remove battery
pack from the charger.
11 - EN
