Idiomas disponibles
Idiomas disponibles
Operating Instructions (Continued)
access the touchpad buttons. The layout of the buttons on touchpads and remote control unit can be seen in
Figures 3 and 5, respectively.
2. Turn the power on. Flame will show on the back screen of the
3. Remove plastic tab from inside battery compartment
to activate remote control.
Battery Replacement Procedure: (Size CR2025)
Battery replacement instruction
Instructions de remplacement des piles
Instrucción de reemplazo de la batería
CR2025
OPEN
OUVRIR
ABRIR
PUSH
POUSSER
EMPUJE
RELEASE
RELÂCHER
LIBERAR
1. Main Power Button:
position, either from the remote or on the touch pad for the functions to work.
2. Timer Button:
turned on, it will come on at the shortest time setting (30 minutes). Each time the Timer button is pressed, the
automatically turned off.
3. Flame Control button:
turn off the Main Power button.
4. Heater Control Button:
This button controls the heater ON/OFF and 11 temperature modes from 68°F
lowest room temperature setting 68°F (20°C). Each time the Heater Control
button is pressed, the temperature set point increases 2°F (1°C), allowing you to
the last heat setting, and in later use, the heater will start at that setting, unless
power to the unit has been interrupted.
NOTE: To switch between Fahrenheit/Celsius modes see
control panel Fahrenheit/Celsius display instructions.
8
FIGURE 4
The plastic tab inside the battery
compartment MUST be removed
before remote control will operate.
(Pull tab)
FIGURE 5
1
2
3
4
