4.12 Operation Tips; Maintenance; General Maintenance; Clear The Clogged Chute - Cramer SNB408 Manual Del Usuario

EN
Do not push the trigger so far forward that a gap
shows between the deflector and the chute.
1. Grip and hold the chute deflector control lever.
2. Pull the chute deflector control lever to the left and
hold to unlock position.
3. Move the chute deflector control lever forward to
adjust the deflector down and decrease the snow
throw distance.
4. Move the chute deflector control lever backward to
adjust the deflector up and increase the snow throw
distance.

4.12 OPERATION TIPS

• If it is possible, clear the snow with the direction of
the wind.
• In strong winds, lower the chute deflector to direct
the snow to the ground.
• When you complete the work, let the machine
operate for a while to prevent ice formation in the
discharge chute.
• If the snow is deeper than 20 cm, decrease the
speed and let the machine work at its own rhythm.
• Do not use the scraper to remove compact snow
and ice.
5

MAINTENANCE

Remove the safety key and battery pack from the
machine before maintenance.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten all the fasteners and caps correctly.
• Clean the remaining snow on the machine with a
brush.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
English
5.2

CLEAR THE CLOGGED CHUTE

• Never use your hand to clean out the chute.
Failure to follow these instructions can result in
serious personal injury.
• Never reach into the discharge chute or place any
body part in front of the snow thrower when the
unit is operating or when the battery packs are
installed.
Figure 17
To clear the discharge chute:
• Loosen the handle to turn off the machine.
• Remove the battery backs.
• Wait 10 seconds to be sure the auger has stopped
rotating.
• Always use the chute clean tool which is attached to
the machine as an accessory.
5.3

REPLACE THE SKID SHOES

The range of adjustable height for skid shoes is
1.5mm, when putting the bolts through the U-hole on
the skid shoes.
Figure 18
1. Loosen the 2 sets of bolts, spacers and nuts that
attach the skid shoe to the snow thrower housing.
2. Remove the skid shoe.
3. Install the new skid shoe.
4. Repeat the same operation on the other side.
5.4

REPLACE THE SCRAPER PLATE

Use only approved replacement scraper plates.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
Figure 19
1. Remove the nuts and spacers from scraper plate.
2. Remove the screws and discard the old scraper
plate.
3. Install the new scraper plate.
4. Reinstall the screws, spacer plates and tighten them
with the nuts.
8
WARNING
NOTE
WARNING
WARNING