stayer TD355W Manual De Instrucciones página 14

Fig.3
Blade
Inner Flange
■ REMOVING THE BLADE
TOOL FROM POWER SOURCE.
Ensure that the motor head is in its fully
1.
r a i s e d a n d l o c k e d p o s i t i o n a n d
unplugged. Remove the four screws
which hold on the outer blade cover
and remove the cover.
Once the cover is removed, use the
2.
supplied 8mm hex wrench on the arbor
bolt. Push in the arbor lock and rotate
the blade with the wrench until the lock
engages the blade arbor.
Once the arbor lock is engaged, turn
3.
the arbor bolt anticlockwise to loosen.
Remove the arbor bolt, flat washer and
4.
o u t e r b l a d e f l a n g e ( n o t e i t s
orientation).
Wearing thick work gloves to protect
5.
the hands, carefully hold the blade
from the top and lift it upwards and
away to remove.
■ USING THE VISE & FENCE SYSTEM
WARNING: The vise must always be used
w it h o u t e x c e p t io n . If t h e v is e c a n n o t
a d e q u a t e l y c l a m p t h e w o r k p i e c e i n
question, then do not use this machine to
cut it. Cutting without the vise can easily
lead to kickback and other hazardous
situations.
Always clamp the workpiece in the most
stable position possible. Ensure that the
b l a d e e n g a ge s t h e w o r kp i e c e i n th e
quadrant behind the center line of the
arbor.
ENGLISH
Outer Flange
Washer
Arbor Bolt
-DISCONNECT
11
The fence swivels to create miter cuts up to
45 degrees and the vise plate swivels freely
to match the angle of the fence.
To adjust the fence to create miter cuts:
Loosen the miter lock lever by turning
1.
counterclockwise. Press with the thumb
while pulling up against the spring
tension to ratchet the lever.
Rotate the fence to the desired angle
2.
and retighten firmly. There are preset
detents for popular angles, but any
angle between 0 and 45 degrees can
be used. See Fig.4.
Fig.4
lock lever
Note: Cutting 45 degree miters may shift the
workpiece forward so far that the blade will
not be able to cut fully through the material.
In this case, use a spacer of at least 31mm
thickness against the fence to bring the
workpiece fully into the range of the blade
arc. (The optional V-Jig Block may also be
used for this purpose).
■ Using the optional V-Jig Block
The V-Jig Block has several purposes:
Holding square-section tubing in a tilted
1.
position so that the blade can more
e a s i l y b e g i n a n d f i n i s h t h e c u t .
Otherwise the blade has difficulty
"biting" into the broad, flat face of the
workpiece. See Fig.5.
11
Fence
Vise Plate