Idiomas disponibles
Idiomas disponibles
NOTE: If location of generator is not level, the unit may
not start or may shut down during operation.
This generator is equipped with electronic fuel injection.
Starting the generator will require a brief wait to allow
the fuel to travel from the tank.
- Unplug all loads from the generator.
- To start the engine using the electric start:
1 Put the engine switch in the ON position.
2 Wait 30 seconds to allow fuel to travel through the
line.
NOTE: The engine will not start until the fuel has reached
the fuel injector and the proper operating pressure is
acheived.
3 Turn and hold the engine switch to the START position.
Do not hold the engine switch in START position for more
than 15 seconds. Allow 1 minute between starting
attempts.
NOTE: The battery may require charging before the
generator can be started using either the engine switch
or the recoil starter. Once the generator is started, the
battery will charge as the unit runs.
OPERATION
- To start the engine using the recoil starter:
1 Put the engine switch in the ON position.
2 Wait 30 seconds to allow fuel to travel through the
line.
NOTE: The engine will not start until the fuel has reached
the fuel injector and the proper operating pressure is
acheived.
3 Pull the recoil starter grip until the engine runs.
NOTE: Do not allow the grip to snap back after starting;
return it gently to its original place.
www.ducsonpower.com
STOPPING THE ENGINE
To stop the engine under normal operating conditions:
- Remove any load from the generator.
- Turn the engine switch to the OFF position.
WARNING:
While operating and storing, keep at least 3 feet of
clearance on all sides of this product, including over-
head. Allow a minimum of 30 minutes of "cool down"
time before storage. Heat created by muffler and
exhaust gases could be hot enough to cause serious
burns and/or ignite combustible objects.
MAINTENANCE
Normal maintenance, replacement or repair of emission
control devices and systems may be performed by any
qualified repair establishment or individual with original
or equivalent parts. Warranty and recall repairs must be
performed by an authorized service center; please
contact customer service for assistance.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off engine, wait for all moving parts to stop, and
disconnect spark plug wire and move it away from spark
plug. Allow 30 minutes of cool down time before perfor-
ming any maintenance. Failure to follow these instruc-
tions can result in serious personal injury or property
damage.
WARNING:
When servicing, use only recommended or equivalent
replacement parts. Service or maintenance performed
by unqualified personnel or use of any other parts could
result in a personal injury hazard or property damage.
Pag: 19
