Important Safety Instructions
Read all instructions before using the appliance.
Child entrapment and suffocation are not problems of the past. Junked or
abandoned appliances are still dangerous... even if they will "just sit in
the garage a few days."
Before you throw away your old wine cooler:
take off the door, leave the shelves in place, so that children may not
easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids. The fumes can create
a fire hazard or explosion.
Do not store or use gasoline or any other flammable vapors and liquids
in the vicinity of this or any other appliance. The fumes can create a
fire or explosion.
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove the exterior and interior packing, including protective foam on
door panels .
Check to be sure the following parts are included:
3 slide out shelves
1 wine rack
1 Instruction manual
Before connecting the appliance to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Wine Cooler
Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the
legs at the front of the appliance.
Allow 5 inches of space between the back and sides of the appliance
,which allows the proper air circulation to cool the compressor.
Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also cause the appliance
not to perform properly.
Avoid locating the appliance in moist areas. Too much moisture in
the air will cause frost to form quickly on the evaporator.
2
