Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Back to back installation
NOTE: If you are not making a reverse or back to back
installation, skip this step and continue with the step 5.
□
If the hot and cold inlets are reversed (hot on
right and cold on left), remove the sleeve (1),
and bonnet nut (2) from the valve body (D) with
reversed supply connections. Rotate the
cartridge (3) 180°, so H appears on the right.
Install the cartridge making sure that the key is
fully engaged with the slot in the valve body (D).
Slide the bonnet (2) over the cartridge (3) and
thread them onto the valve body (D).
bonnet (2) securely with adjustable wrench until
the o-ring on the valve body (D) is covered
completely. Reassemble the sleeve (1), and
hand-tighten it only.
NOTE: Never install the valve body (D) upside down!
The appropriate locking torque of the bonnet (2) is
10~12 N·M. Do not over-tighten it.
3
2
1
Reverse
installation
Hot
Cold
Reverse installation
Tighten
Normal
installation
(changes
not required)
Cold
D
Hot
Normal installation
Hot
5
Installing the shower arm
□
Insert the long end of the shower arm (B) through
the shower ange (A), and wrap thread sealant
tape (not included) around the long end of the
shower arm (B) in a clockwise direction, as shown.
□
Install the long end of the shower arm (B) into the
pipe elbow inside the wall. Carefully tighten the
shower arm (B) with a clean strap wrench. Do not
over tighten.
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Connect the tub spout outlet pipe (the tub spout
outlet pipe should project 3-27/32 in. from the
nished wall) to the lower pipe elbow (2, not
included). Tighten the elbow and tub spout outlet
pipe connections with a strap wrench.
B
Cold
9
Please contact 1-855-HD-GLACIER for further assistance.
A
2
1
3-27/32 in.
1
HOMEDEPOT.COM/GLACIERBAY
Wall
