Idiomas disponibles
Idiomas disponibles
Maintenance of the byko-spectra mini
Cleaning
When to Relamp the byko-spectra mini
Replacing the Lamps
Fluorescent Lamp „Flicker" Note
Maintenance of the byko-spectra mini
NOTE: Disconnect the power cord before
cleaning or relamping the byko-spectra mini!
The viewing area of the byko-spectra mini should
be kept clean and free of samples, notices, etc. To
clean the neutral gray surface, use a soft, damp
cloth with a mild soap or detergent. For stubborn
marks or stains, use a non-abrasive "soft-scrub"
type of cleaner. DO NOT use organic solvents on
the surface.
In order to maintain proper color quality and light
intensity, the lamps should be replaced after 2,500
hours use. It is important to use a BYK-Gardner
daylight source when relamping. To order replace-
ment lamps for your light booth, refer to the
product label on the rear of the unit (located near
power cord) for a relamp kit code.
Rotate the lamp 90 degrees to remove it from its
lampholders. The tubular incandescent lamp has a
screw-type base, which unscrews like a standard
incandescent bulb. After removing the lamps, wipe
the polished reflectors with a soft, damp cloth,
to remove any accumulated dust. Install the new
lamps into their appropriate sockets.
The fluorescent lamps may flicker or „spiral" when
new. This is a common characteristic of new
fluorescent lamps and does not indicate that the
lamps are defective. Normally, flickering gradually
diminishes then disappears after approximately 50
hours of operation. Flickering can be eliminated
more rapidly by (1) turning the light booth on and
off, rapidly, a few times or (2) by removing the
15
