Pur Line DRYOS 10 Manual De Instrucciones página 11

2. Timer
In the condition of working, press the timer button to set 2h, 4h and 8h timer or cancel. Press again, it will start
from the beginning.
(1) The unit will auto-off when water tank is full even if the unit is timing, and the remaining time will still be
recorded. After emptying the water tank, the unit will keep working in remaining hours.
(2) When the water tank is not full, the function of timing could be set in any timer. If the unit stops working or
cut off, it needs to be reset.
3. Humidity
(1) Press the humidity button to dehumidify under the condition of RH50%, RH60% or Auto , then the
corresponding indicator turns on.
Press the button again, it will start from beginning.
(2) When the environmental humidity is lower than the setting humidity, the unit will stop dehumidifying.
When the environmental humidity is higher than the setting humidity, the unit will start dehumidifying again.
Notice: When the unit is in the status of automatic dehumidifcation, its operation wouldn't be effected by the
change of environmental humidity.
4. Cloth Dry
Press the cloth dry button, the unit will work with strong mode, user could set timer and humidity, but the
function of dehumidification can't be set.
If the unit doesn't work under timer, the unit will keep working for 10 hours and then stop for half an hour, then
it will restart automatically.
5. Swing
In the condition of working, the position of the wind deflector could be controlled by the fan setting button.
Press fan setting button could set the wind deflector between swing and stop status. The wind deflector can
swing or stop at any angle within 90 degrees.
METHODS OF POURING WATER
The water tank has maximum capacity of 2.5L with 10L per day working capacity.
When the tank is full, the machine will stop dehumidifying immediately . The full indicator will keep flashing
in orange.
Pour Water From Water Tank
Turn off and unplug the device.
1. Take out the water tank. 2. Remove the water tank
Continuous Drainage
Plastic
block
cover.
1. Turn off the device, take out the water tank and cut off the plastic block of the
continuous drainage hole.
2. Extend the drain pipe from the continuous drainage hole to the inside of the
device and then insert the drain pipe into the drain hole from the mouth of the tank.
3. After resetting the water tank, it can restart to dehumidify. If turn on the device
without resetting the water tank, the machine will be in protected status.
Protected status: water full indicator and power indicator will keep flashing .
EN
3. Pour water.
9
4. Reset the water tank
and it will restart.