Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Symptom
Machine turns on but it does not
draw any water or there is not
sufficient pressure.
Multi-spray nozzle leaks.
Outlet pressure increases
suddenly.
Machine drains out water after
stopping.
Soap accessory cannot spray
out any detergent.
Machine does not start.
Machine pressure is not
consistent.
Machine stops automatically.
Machine does not draw any
water after long time storage.
Cordless Portable Power Cleaner
Possible causes
Power nozzle is too high from the water
source surface.
Hose filter is blocked.
The users' garden hose is not well
connected to the machine.
Hose adapter looses.
The filter screen is missing. (See Fig.
P1, P2)
The filter screen is blocked. (See Fig.
P1, P2)
Pump, hose, or other parts are frozen
due to outside temperatures.
Hose kinks.
The nozzle pattern does not spray
correctly.
Fixing nail of the multi-spray nozzle
loosens.
Multi-spray nozzle is blocked.
There is water remaining in the lance
and pump after stopping.
Blockage in the soap bottle.
The battery pack is not attached well.
Battery pack is empty.
Defective battery.
Additional air could be sucked into the
machine.
It is at low pressure setting.
Battery pack is empty.
The multi-spray nozzle is blocked. The
current protection is activated.
Additional air could be sucked into the
machine.
Solution
Lower the machine below 5ft/1.5m.
Take out the hose filter and rinse the
parts with clean water. (See Fig. O1, O2)
Check and reattach the garden hose
tightly. (See Fig. F)
Tighten the hose adapter securely with
a spanner.
Contact Worx service agent to get a
filter screen.
Clean the filter screen regularly.
Wait for the pump, hose or other parts
to thaw.
Straighten out the hose.
Make sure the nozzle pattern symbol
aligns with the indicator mark on tool.
Tighten it with a hex key.
Replace with a new multi-spray nozzle.
Drain all the water completely before
storage.
Clean it with fresh water.
Reinstall the battery pack.
Replace with a new battery pack or
recharge the battery pack.
Replace with a new battery pack.
Check connection between the hose
adapter and the draw hose.
No action need.
Replace with a new battery pack or
recharge the battery pack.
Remove the multi-spray nozzle and turn
on the machine. If the machine works
normally, replace with a new multi-spray
nozzle.
Connect the machine to the water
source and then turns it on.
15
EN
