Idiomas disponibles
Idiomas disponibles
Desk fan Use instructions
Description of the item Fig.A
1. Motor
2. Shaft
3. Rear grill
4. Nut
5. Blade
6. Cap
7. Front grill
8. Control pannel
9. Power cord
Assembling instructions Fig.B-C
Unscrew the blade cap by turning clockwise and rear gard mounting nut by turning counterclockwise
Put rear grill on motor shaft and screw with guard nut.
Slide blade on motor shaft.
Screw blade cap on shaft by turning counter clockwise.
Put front grill on rear grill, close clips and screw the small screw on the edge to secure grilles together.
Operating instructions
To make the fan head oscillate, push in the knob on the motor housing.
To adjust vertical angle, tilt fan need up or down as desired than screw the knob.
Attention: do not try to force the inclination position in order to avoid any failure.
Plug the power supply cord into a wall outlet.
Speed is controlled by depressing the push-button piano switches on control panel
Cleaning
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not spray water or other liquids on the fan in order to protect it.
After cleaning, dry every parts before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.
Technical data
Power : 30W
Power supply : 220-240V~ 50Hz
For any improvement reasons, beper reserves the right to modify or improve the product without any
notice
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you
dispose of the appliance, it must be separately collected.
9
EN
