Idiomas disponibles
Idiomas disponibles
take control
LIFT:
Press and hold to lift the chair for easier entry/exit; press and hold again to lower the chair to the floor. NOTE: To
change while the chair is lifting, release the button for five seconds, then press and hold it again to lower the chair to
the floor. WARNING: The underside of the chair lights when lifting/lowering to illuminate the area underneath the chair.
Make sure the area underneath the chair is free of any obstruction before lowering the chair to prevent injury or damage.
NOTE: When the chair is in the LIFT position, all other functions are disabled.
RESTORE:
When the chair is reclined
and/or the footrest is raised, press and
hold to restore the chair to the upright
position with the footrest lowered.
ZEROG:
Press to automatically recline
the chair to the ZeroG position. To stop
the automatic recline, just press the
button again.
HEAD:
Press and hold to inflate or deflate
the headrest.
BACK:
Press and hold to raise or lower
the backrest.
HEAT:
Press to toggle through the
following heat settings:
• Red - backrest, seat and legrest heat
• Green - backrest heat only
• Orange - seat heat only
• Violet - legrest heat only
The heat automatically turns off
after 15 minutes.
relaxtheback.com
MEMORY:
To save the chair's current
backrest and legrest position for easy
recall, press and hold the MEMORY button
until it flashes blue. Press the MEMORY
button to recall the saved position.
LEGS :
Press and hold to raise or lower
the legrest.
LUMBAR:
Press and hold to inflate or
deflate the lumbar support.
NOTE: The lumbar support automatically
deflates very slowly over time.
MASSAGE:
Press to toggle through the
following vibration massage programs:
• Red – Full-body massage
• Green – Back massage
• Orange – Seat massage
• Purple – Leg massage
STOP: Press to deactivate the Heat
and Massage functions; press again to
enable them.
12
Once you're in the desired position, you can use the memory setting
to store it for future use. Then choose one of four vibration massage
programs. And don't forget to add soothing seat and backrest heat for
extra muscle relaxation.
USING THE BACKUP BATTERY
Your zero gravity recliner power supply contains a rechargeable lithium-ion battery pack, which allows you to operate the
chair during a power failure (battery life varies depending on chair usage). See "Checking the battery status" below for
information on monitoring battery status when the chair is operating under battery power.
USING THE CHAIR UNDER BATTERY POWER
You can also use the built-in battery to power the chair with the power supply unplugged
from a wall outlet (battery life varies depending on chair usage).
Checking the battery status
Press the battery Test button to check the battery status. If the LED does not light, the battery is in
sleep mode and will wake up while charging.
• If the LED lights green, the battery is charged and ready for use.
• If the LED lights amber, the battery will still operate the chair but will need to be charged soon.
• If the LED lights red, the battery must be charged to operate the chair.
Recharging the battery
1. If the chair is not positioned near a wall outlet, disconnect the power supply from the chair power cable.
2. Plug it into a wall outlet. The Charge LED lights to indicate it is charging.
3. When the Charge LED lights green, unplug the power supply from the wall.
4. Plug the power supply into the chair power cable.
Conserving battery life
To conserve battery life when the chair is not in use, place the battery in sleep mode:
1. Push and hold the battery Test button for five seconds until the Test and Charge LEDs flash green.
NOTE: When in sleep mode, the battery Test button LEDs are disabled.
2. To exit sleep mode, press and hold the battery Test button for five seconds until the Test and Charge LEDs light solid green.
NOTE: Do not allow the battery pack to completely drain, as this may reduce the battery life.
Test button
TEST
CHARGE
13
