Rain Bird TBOS Manual De Instrucciones página 9

english
Transmitting Programs to a
Control Module
When you want to transmit (download) program
data to a Control Module:
1. If the Field Transmitter's display is blank,
B
press .
2. If you have not already done so, enter the pro-
gram data into the Field Transmitter.
3. Plug the Field
Transmitter's optical
connector onto the
Control Module's
optical connector.
R
4. Press .
W
The icon will appear on the screen for two sec-
onds. When the icon disappears from the display, the
program data has been successfully transmitted.
Important: If there is a transmission
W
problem, the
display and you will hear three beeps.
E
Then the icon will appear.
Verify that the:
• Field Transmitter and the Control Module are
connected properly
• Field Transmitter's and Control Module's optical
connectors are clean (wipe the connectors with a
damp cloth)
• Field Transmitter and Control Module have a
fully charged 9-volt alkaline battery
B
• Press and then transmit the programming
information again.
icon will appear in the
14
TBOS ™
Field Transmitter
5. Disconnect the Field Transmitter from the
Control Module.
Reviewing Control Module programs
When you want to verify the program data of a
Control Module:
1. Plug the Field Transmitter's optical connector
onto the Control Module's optical connector.
2. If the Field Transmitter's display is blank,
B
press .
T
3. Press on the Field Transmitter to receive
(upload) the program data stored in the Control
Module. You can now review all of the Control
Module program data except the current time of
day stored in the Control Module.
Note: The Field Transmitter does not
receive the current time from the
Control Module because there may be
a difference in the current time between
the two devices. However, when you
transmit (download) a program to a
Control Module, the Field Transmitter
synchronizes the Control Module's cur-
rent time with the Field Transmitter's
current time.
Note: if a TBOS Field Transmitter set in
Standard mode receives a Turbo mode
program from a TBOS Control Module,
the Field Transmitter will automatically
switch to Turbo mode and the display
will show "turbo" for three seconds.
4. To modify the program data stored in the Control
Module, enter the desired modifications into the
Field Transmitter, then press
(download) the program to the Control Module.
15
english
R
to transmit