Idiomas disponibles
Idiomas disponibles
Numero
Serial
Nombre
Tambor
Fig.2
The phase order must not be violated for three- phase motors. When the rise- up becomes downside,
the motors must be immediately stopped for readjustment of the phase order . If an interim power
source is used for testing; attention should be given to connect in correct sequence when normal power
source is introduced.
The correct operation approach is as follows: when the rise- up button on the White line is pressed, the
motor should turn anti- clockwise, allowing the position limiting device to function. See Fig . 1 for details.
Otherwise the shutter door would be out of control and will be damaged.
Testing:
Nota: Instalación
Screw cap position limiting slide piece model (Fig 2. 1)
Loosen the Locking Bolt (No. 3) of position limiter before testing, and then pull the hand chain to lift the
Código NO.
door 1 meter above the floor. Press 'up' 'stop' and 'down' button, observe these functions of rolling
shutter operation to see if they are correct. After you have confirmed that the door is working well, then
open the door up or down to the position that you desire, turn the position limiter slide piece (No. 6) until
Valores
it touches joggling switch (No. 2) and you hear ' ticktack ' . Screw tight the Locking Bolt (No. 3), and
repeat the testing until the limiter is at the best position. Finally, screw the locking bolt tight again.
Nota: Para el HULK550DC tomar como referencia los valores de 600Kg.
Gear form screw nut position limiting board model (Fig 2. 2)
Loosen the two locking bolts (No. 3) of position limiter, before testing. Hold the middle of position limiter
Opening your life
board (No. 6) with your fingers, push it 4mm to the left side←, and pull away the ↓ screw 4mm. The
position limiting board will be separated from the gear form screw now. Turn the gear form screw nut
1
2
Engranaje
Interruptor de
limitador de
desplazamiento
posición
Diagrama de instalación del
hacia el lado derecho, Modelo del motor de la puerta del obturador Dl
D1
400kg
Φ30
600kg
Φ35
800kg
Φ35
Opening your life
3
4
Perno de
Cable de
bloqueo
engranaje
D2
D3
4"
5ʺ
6"
3
Code:
5
Tuerca del
tornillo
deslizante
limitador de
limitadora de
posición
posición
L
C
Soporte
35
3
206
35
4
207
35
5
207
www.accessmatic.com
HULK550DC
6
Pieza
