Idiomas disponibles
Idiomas disponibles
DIGITAL TUNER
To improve radio reception:
• For FM, pull out the telescopic antenna.
Incline and turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).
• For AM, the set is provided with a built-in antenna so the
telescopic antenna is not needed. Direct the antenna by
turning the whole set.
Programming tuner stations
You can store up to a total of 30 tuner stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
flashes.
PROG
3. Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
disappears, the preset number and the frequency
PROG
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
GENERAL INFORMATION
11
