Idiomas disponibles
Idiomas disponibles
EN
•
Position the new blades including the sliding plates (9).
•
Install the hinge pins (2).
•
Install the screws (1) in the hinge pins.
CAUTION
These screws are provided with a reuseable locking jelly. Holmatro advises to use these
screws 10 times at the utmost and then to replace them.
•
Install the cutter bolt (7).
•
Install the castle nut (6) and tighten with a torque of 50 Nm.
•
Position the toothed locking disc (5) by rotating or to turn around the ring in such a way that:
-
The inside notches match with the teeth on the cutter bolt;
-
The outside teeth match with the crenels on the castle nut.
•
Install the cover ring (4).
•
Install the screw (3) in the cutter bolt.
8.5.8
Carrying handle
•
Check if the carrying handle has been securely attached. Firmly re-tighten the knob.
8.6
Yearly dealer maintenance
We recommend having the equipment inspected, checked, set and tested once a year by a Holmatro
Certified Technician who has the appropriate knowledge and the necessary tools (see also section 1.7).
The Holmatro dealer can organize the yearly maintenance for you on a contract basis.
8.7
Long term storage
•
Ensure that the equipment is completely depressurized.
•
Store the equipment in a dry, well-ventilated area. Use additional preservatives on the external steel
parts.
9
Decommissioning/Recycling
At the end of its service life the equipment can be scrapped and recycled.
•
Make sure that the equipment is put out of order to avoid any use.
•
Check that the equipment does not contain any pressurized components.
•
Recycle the various materials used in the equipment such as steel, aluminium, NBR (Nitrile
Butadiene Rubber) and plastic.
•
Collect all dangerous substances separately and dispose of them in an environmentally responsible
way.
•
Consult the Holmatro dealer about recycling.
40
916.000.905_002
ICU05/10
