Idiomas disponibles
Idiomas disponibles
3 41 01 074 06 0.book Seite 15 Donnerstag, 5. November 2015 10:04 10
Note: The maximum permissible protruding shaft
length (5f) of the wheel arbor must not exceed 8 mm.
Lock the drive spindle using the open-jawed
wrench, size 17 mm (3b) and screw the collet
chuck (1) in tightly using the open-jawed wrench,
size 13 mm (3a).
Mount the grinding wheel (5g) and the disc (5h)
onto the wheel arbor.
Lock the clamping collet (1) with the open-
jawed wrench, size 13 mm (3a) and tighten the
hexagon nut (5i) with the open-jawed wrench, size
17 mm (3b).
Securing the work piece.
Secure the workpiece adequately. A workpiece that
is not properly secured can, for example, cause the
accessory to jam and kick back, fall and cause other
hazards.
General operating instructions.
Switching ON and OFF (Figure 2).
First check that the mains supply lead and mains
plug are not damaged.
Switching ON:
Push the switch (2) forward (I).
Switching OFF:
Push the switch (2) towards the rear (0).
Working instructions.
Using the same pressure, move the power tool back-
wards and forwards across the surface of the work piece
to prevent it from becoming too hot.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power
tool. The total insulation of the power tool
can be impaired. Blow out the interior of the power tool
via the ventilation slots frequently with dry and oil-free
compressed air, and connect a residual current
device (RCD) on the line side.
If the supply cord of this power tool is damaged it
must be replaced by a specially prepared cord avail-
able through the FEIN customer service centre.
The current spare parts list for this power tool can be
found in the Internet at www.fein.com.
If required, you can change the following parts yourself:
application tools, collet 6 mm.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. FEIN GmbH,
C-DB_IA, D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environment-friendly recycling.
Accessories.
Only use accessories recommended by FEIN.
en
15
