TO ASSEMBLE BAGGER
•
Unfold bag and stand right side up.
•
Feed front bagger frame (1) up through fabric loops at each
side of bagger.
•
Snap bottom of front bagger frame (1) into snap feature at
front of bagger bottom.
•
Slide bagger fabric loop (2) segments at the ends of bag
onto top bagger frame tubing.
•
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the front of
top frame.
•
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through holes
at top of the front bagger frame and thread into nuts inside
the tubing of top bagger frame.
•
Uninstall (1/4"-20) lock nuts (4) at bottom of front bagger frame.
•
Unfold cross braces (5) and attach to carriage bolts at bottom
corners of front bagger frame.
•
Reinstall (1/4"-20) lock nuts (4) and tighten until fully seated.
•
Install corner support brackets.
• Place the bottom of the corner support bracket (6) into
the corner of the bagger bottom.
• Push corner support bracket into the corner until the upper
hole is aligned with the hole in the upper bar.
• Secure corner support bracket to the upper bar (7) with
fastener (8).
• Repeat procedure on other side.
7
6
•
Remove clevis pin (9) and retainer spring (10) from bagger
handle (11).
•
Slide bagger handle (11) down through bagger cover and
frame upper weldment holes.
•
Reinstall clevis pin (9) through hole at bottom of bagger
handle and slide retainer spring (10) into hole at the end of
the clevis pin until it locks into place
TO ADJUST PIVOT BRACKETS (12)
The tractor comes from the factory with the bagger pivot bracket
preset in a fixed position. If necessary, this position can be adjusted
to maintain a consistent gap (A) between the fender and the bag-
ger assembly top. An ideal gap is approximately 0.2" (5.1mm).
NOTE: As desired, the pivot bracket on either side can be ad-
3
2
justed in this manner.
•
Remove bagger assembly.
1
•
Remove fixed (3/8"-16) bolt (13). Bolt is no longer necessary
for use with tractor.
•
Loosen remaining three (3/8"-16) bolts (14) so that pivot
bracket (12) can slide. Do not remove bolts.
•
Adjust pivot bracket (12) to desired position and retighten
three (3/8"-16) bolts (14).
•
Check the gap (A) between fender and bagger.
•
Readjust if necessary.
8
TO ADJUST BAGGER FULL LEVER/EXTENSION
•
Before adjusting, tractor engine must be shut off and parking
brake engaged.
5
4
Slide bagger full extension to the desired position (15).
•
For the heaviest/wet grasses, slide extension all the way in.
•
For the lightest/driest grasses, pull extension all the way out.
23
10
12
13
2
11
9
A
14
15
