Warning; Installation - Frucosol SELF-SERVICE Manual De Usuario

Read all instructions carefully before using the machine and keep them for future references.The manufacturer
declines all responsibilities if the standards of the manual are not respected. The present machine is an
automatic juicer for citrus fruits. This machine should be only used for the purpose for which it has been
designed. Any other use is inappropriate and therefore dangerous. The manufacturer will not be responsible
for any damage caused by inappropriate use. Before installing and using the machine read carefully this
instruction manual. The manufacturer will be able to introduce technical or aesthetic changes without
previous notice.
Improper installation may damage the orange juicer machine. Please note the following during initial
installation and whenever the orange juicer is moved.
1.- UNPACKING
- Place the box on a plane surface and with the arrow of the box always pointing out up.
- Cut the external strips. Open the inferior part where it is leaning the machine and take out the
cardboard container throwing up.
INSPECT THE MACHINE FOR POSSIBLE DAMAGES DURING TRANSPORT OR UNDUE HANDLING. If it was
necessary present a reclamation before 24 hours to the transport company.
- Retire the poli styrene pieces that are protecting the machine.
- Once carried out these operations, proceed to check that all the elements of the machine are in the right
position, according to the "Part name" section.
2.- POSITIONING
- To assure a good working, place the machine in a completely plane surface.
- Level the machine out with the help of support feet.
- Don't move the machine when it´s working.
3.- ELECTRICAL CONNECTION
- AVOID ALL ACCIDENTAL GROUND STARTING. Before connecting the machine, verify that all the element
of the machine are properly placed; otherwise it could cause a breakdown.
- CHECK THAT VOLTAGE OF ELECTRIC NETWORK is the same as the one shown in the identification sheet
of the machine.
- THE CONNETION INSTALLATION should possess differential protection and own thermal magneto, also
protected upstream.
- DO NOT START THE MACHINE IF THE ELECTRIC CABLE OR PLUG ARE DAMAGED.
- CONNECT THE PLUG to the electric network (230 V - 220 V - 110 V)

5. WARNING

6. INSTALLATION

49
EN