Saurium WARRIOR ATTITUDE KE-WP10A Manual Del Usuario página 34

Idiomas disponibles

Idiomas disponibles

STORING FOR A LONG PERIOD
1. Drain water out of pump, sucking and discharge pipes.
2. Drain fuel out of fuel tank and carburetor float chambers.
3. Store it at dry and no dust place
TROUBLE SHOOTING
Cannot start engine
Trouble
Sparking plug
The sparking
Plug
miss
fire
Magneto
Compression ratio
is fine and
fueling normally
Fueling well but
The sparking
compression ratio
plug
works
bad
normal
Carburetor no
fueling
� THE ENGINE OUTPUT IS INSUFFICIENT
Trouble
The compression ratio is fine, and the fire has not
gone out
Engine overheats
Causes
1. Firing device wetted
2. The carbon lay down on the sparking
plug
3. The spark gap is too big or too small
4. The poles of sparking plug burned
5. The insulation damaged
1. The junction of wire drop off or broken Tighten or replace it
2. The insulation of coil bad
3. The gap between stator and rotor is too
big
1. The fuel suck in excess
2. The quality of fuel is bad and mix with
water and dirty
Cylinder and piston ring wore or tore
1.
No fuel in the tank
2.
Fuel cock is not open
3.
The air hole of the tank clogged
1.
The union of fuel pipe suck in
the air
2.
The connection of
carburetor suck in air
3.
The fuel mix with water
4.
The filter plate clogged
5.
The carbon clogs
muffler, cylinder
1.
Mixed gas thin
5
Remedies
Dry it out
Clean the carbon
Adjust gap at
0.6~0.7mm
Replace it
Replace it
Change
Adjust gap at 0.4mm
Reduce the fuel
Change the fuel
Replace them
Feed the fuel
Open it
Clean
Causes
Tighten it
Change seal and
tighten it
Change the fuel
Clean
Clean
Adjust the
carburetor
Remedies
loading

Productos relacionados para Saurium WARRIOR ATTITUDE KE-WP10A