1
FUNCTIONING OF THE DIVICE
It's possible to configure the activation threshold from 10 to 150lux, with procedure at par.4.
When the measured light level is below this threshold, EOS sends a command; in case of the measured light level
exceeds the threshold of the 50%, EOS sends the opposite command, as well as in case of timed activation of the
receiver (see par.5).
The brightness level is checked every 20 seconds in the first 13 minutes after power on / programming to then switch
to a frequency of 20 minutes.
The functioning modes are the following:
•
turning on any load (ON/OFF type) if below the threshold, turning off if over the threshold (+50%).
•
screen mode: it closes the application if below the threshold, it opens again if over the threshold (+50%).
•
turning on at 100% of the load if below the threshold, turning off if over the threshold (+50%).
This mode is suitable for dimmer to control led strips or led lights, halogen, fluorescent or incandescent lamps,
heating and ventilation systems.
•
starting the automatic colour cycle in RGB controller if below the threshold, turning off if over the threshold (+50%).
The configuration of the desired functioning mode can be executed by means of the procedure at par.3.
After the configuration of the device, it can be memorized in one or more compatible receivers.
2
CONFIGURATION OF THE FUNCTIONING MODE
Press P3 button as many times as the desired functioning mode:
Press
LED signal
5
both led ON
6
red led ON
7
green led ON
8
red led flashing
The value is automatically memorized 2 seconds after the button release.
Attention: it's not possible to set more than one functioning mode in the device.
3
MEMORIZATION OF THE TRASMITTER
For its proper functioning, EOS needs to be memorized in the memory of the compatible receiver it will control. In order to
execute the memorization please refer to the procedure contained in the receiver's instructions manual. According to the
functioning mode configured at par.3, the transmitter must be memorized considering the following table:
Function
ON/OFF loads
Screen
Dimmer 100% - OFF
RGB cycle - OFF
4
SETTING THE ACTIVATION THRESHOLD
1. Press ATT button until the led are ON, then release.
2. Press ATT button as many times as the desired value:
Press
LED signal
1
both led ON
2
red led ON
3
green led ON
4
red led flashing
5
green led flashing
3. Press MEM button to save and exit.
5
SETTING THE TIMER FOR THE TIMED COMMANDS
1. Press MEM button until the led are ON, then release.
2. Press MEM button as many times as the desired value:
Press
LED signal
1
both led ON
2
red led ON
3
green led ON
4
red led flashing
5
green led flashing
3. Press ATT button to save and exit.
Function
ON/OFF loads
Screen
Dimmer 100% - OFF
RGB cycle - OFF
Memorization procedure
Double channel, press P1 more than 3 seconds
Double channel, press P1 more than 3 seconds
7 channels transmitter, press P1 more than 3 seconds
7 channels transmitter, press P1 more than 3 seconds
Value (lux)
150
100
Value (ore)
deactivated
Below threshold
ON (CH1)
CLOSE (CH2)
100% (CH1)
START CYCLE (CH6)
50
25
10
2
4
6
8
Over threshold
OFF (CH2)
OPEN (CH1)
OFF (CH7)
OFF (CH7)
