Idiomas disponibles
Idiomas disponibles
Installation instructions
!
This instruction manual should be kept in a safe place
NA
for future reference. If the washer is sold, transferred or
moved, make sure that the instruction manual remains with
the machine so that the new owner is able to familiarise
himself/herself with its operation and features.
!
Read these instructions carefully: they contain vital infor-
mation relating to the safe installation and operation of the
appliance.
Unpacking and levelling
Unpacking
1. Remove the washer from its packaging.
2. Make sure that the washer has not been damaged
during the transportation process. If it has been damaged,
contact the retailer and do not proceed any further with the
installation process.
4. Close off the holes using the plastic plugs provided.
5. Keep all the parts in a safe place: you will need them
again if the washer needs to be moved to another location.
!
Packaging materials should not be used as toys for
children.
Levelling
1. Install the washer on a flat sturdy floor, without resting it
up against walls, furniture cabinets or anything else.
4
3. Remove the 4 protective
screws (used during tran-
sportation) and the rubber
washer with the correspon-
ding spacer, located on the
rear part of the appliance
(see figure).
2. If the floor is not perfectly
level, compensate for any
unevenness by tightening
or loosening the adjustable
front feet (see figure); the an-
gle of inclination, measured
in relation to the worktop,
must not exceed 2°.
Levelling the machine correctly will provide it with stability,
help to avoid vibrations and excessive noise and prevent it
from shifting while it is operating.
Minimum Installation Spacing
Recessed Front View
0" *
Side View
1"
This appliance may be installed in a recessed area, closet
or alcove. The installation spacing is in inches and is the
minimum acceptable.
*Additional spacing should be considered for easy instal-
lation, servicing and compliance with local codes and
ordinances. Installations must conform with the minimum
dimensions indicated.
0" *
1" *
