GrowMax Water GARDEN GROW 480 Manual De Instrucciones página 3

Ocultar thumbs Ver también para GARDEN GROW 480:

Idiomas disponibles

GARDEN GROW • Setup:

1. Main unit

2. Inlet tubing with garden hose

connector

3. Sediment filter

4. Green coconut carbon filter

5. Outlet tubing

6. Garden hose connector

NOTE: A flow restrictor is built into

thebrass connecting fitting between the two

housings. This gives optimum contact time

for maximum contaminant removal.

Before Installation/Precaution!

*Note: Do not install the system where the incoming water pressure may

be more than 90psi (6 k/cm2). If unsure, check the pressure with a pressure

gauge, available at your local hardware store. If your water pressure is

more than 90psi (6 k/cm2) install a pressure regulator, available at your

Grow Max Water dealer or hardware store. Do not use with hot water.

How to install the GARDEN GROW unit:

1. Begin by connecting the garden hose adaptor to your garden hose

or garden tap.

2. Then take a length of 3/8" tubing (cut your desired amount) and push

one end into the the garden hose adaptor and the other end into the

"feed" inlet port of the filter system on the right side.

3. Then take another length of 3/8" tubing (cut your desired amount) and

push one end into the other garden hose adaptor and the other end

into the "outlet" port on the left side of the Garden Grow filter system.

4. You can now connect up your garden hose to the outlet Garden hose

quick connect or you can just use the 3/8" tubing for direct watering.

5. Before using the system you will need to flush out any carbon fines

and particulates. You simply open the water and flush out the system

for 5 minutes letting the water go to the drain.

You are now ready to use your system!