Idiomas disponibles
Idiomas disponibles
TROUBLE SHOOTING
The tasks described here for troubleshooting can be done mostly by the operator.
Some tasks only may be done by specially trained personnel or by an Oster
tasks are marked with (*).
MALFUNCTION
CAUSE
Top blade does not move Clipper-head is not well engaged
Drive carrier is defective
Clipper cuts badly or not
Clipper blade is blunt
at all
Clipper Blades have not been
correctly grounded
Clipper blades are not oiled
Hairs jammed between top and
bottom blades
Clipper-head has too little clipping
pressure
Motor is not running
Battery is not charged
Contacts dirty
Faulty battery
Smell of burning from the motor
housing. Motor burned out
Motor and / or electronics faulty
Clipper-head blocked
Motor runs very slowly
Clipper blades were not oiled
sufficiently
Running time of a fully
Clipper blades were not oiled
charged battery is too
sufficiently
short and / or blades are
Battery is not fully charged, or
getting hot
faulty battery is being used
When battery is
Contacts dirty
unloaded the light does
Faulty battery
not change from green
Contacts of the charging station are
to red
deformed
076076CL_078005CL_076076-810-050_078005210-050_21MLM2 (EMEA).indd 10-11
076076CL_078005CL_076076-810-050_078005210-050_21MLM2 (EMEA).indd 10-11
English
TM
authorized service center. These
RECTIFICATION
Engage the clipper-head correctly when the
motor is running
Replace drive carrier (*)
Have top and bottom blades re-sharpened by
Oster
authorized service center
TM
Oil clipper blades every 15 minutes
Take off clipper-head, push the top blade half
away from the clipper head, take away hairs
between top and bottom blade
Have clipper-head inspected (*)
Charge battery
Switch clipper «OFF» (O) and clean the
contacts
Replace battery (*)
Have motor and / or electronics replaced (*)
Have motor and / or electronics replaced (*)
Clean and oil clipper-head
Oil clipper blades
Oil clipper blades
Only use intact, fully charged original batteries
Clean contacts
Replace battery (*)
Have the charging station repaired (*)
10
WASTE DISPOSAL
WARNING
BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY.
1. The battery must be removed from the appliance before it is scrapped.
2. The appliance must be disconnected from the supply mains when removing the battery.
3. The battery is to be recycled or disposed of safely.
4. For battery removal or maintenance please contact an Oster
Disposal in E.U. countries
Do not dispose of the appliance with domestic refuse and do not throw them into fire or water. As part of the E.U.
Directive governing the disposal of electric and electronic appliances, the appliance is accepted free of charge by
local waste collection points or recycling centres. Correct disposal will ensure environment protection and prevent
a potential harmful impact on people and the environment.
Disposal in non-E.U. countries
Please dispose of the appliance at the end of service life in an environmentally friendly manner, per applicable
local and national laws and regulations.
AFTER SALES AND REPLACEMENT PARTS
In the case the appliance does not operate but is under warranty, return the product to the place it was purchased
for a replacement. Please be aware that a valid form of proof of purchase will be required. For additional support,
please contact our Consumer Service Department at: + 49 (0) 6190-93443-0. International rates may apply.
Alternatively, e-mail: [email protected].
English
Authorized Service Center.
TM
11
2021/10/29 下午4:59
2021/10/29 下午4:59
