I - Pivot Bracket; K - Mixing Tine - Ryobi RMX001 Manual Del Operador

SECURING THE DRUM
See Figure 12.
CAUTION:
Double check all setups. Make sure that the legs, pivot
bracket, wheels, motor assembly, and handles are
installed correctly prior to installing the drum.
 Locate the drum.
 Tighten the bolt at the rear of the pivot bracket to
prevent the drum from rotating.
 With the help of a second person, place the drum onto
the motor shaft.
NOTE: The drum is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Screw the drum onto the motor shaft by turning it
clockwise. Tighten securely.
INSTALLING THE MIXING TINES
See Figure 13.
 Locate the following parts:
Mixing Tine ................................................................... 2
Nut (12 mm) in plastic bag (D) ...................................... 4
Bolt (Phillips Hd.) in plastic bag (D) .............................. 4
 Place the mixing tines into the drum with the angled ends
pointing toward the inside of the drum.
 Align the holes in the tines with the holes in the drum.
 Install nuts and bolts as shown. Tighten securely.
ASSEMBLY
MOTOR
ASSEMBLY
13 − English
SHAFT
TO
TIGHTEN
DRUM
PIVOT
BRACKET
Fig. 12
NUT
BOLTS
MIXING
TINE
NUT
Fig. 13