PowerFit PF31099 Guia De Inicio Rapido

11 in. Surface Cleaner Attachment
PF31099/PF31099VN/PF31099VNM
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their pressure washer before us-
ing this accessory. To reduce the risk of injury or property
damage, spray the pressure stream in a safe direction to
ensure proper connection of all accessories before start-
ing any cleaning project. Only use on pressure washers
operating at up to 2,000 psi with a maximum flow rate of
1.4 gpm. Ensure compatibility and proper fit before using this
accessory. Wear eye protection with side shields marked to
comply with ANSI Z87.1. Risk of fluid injections; do not point
at people, pets, electrical devices or the unit itself. Turn off
the pressure washer, relieve the water pres sure in the trig-
ger handle, and lock the lock out on the trigger handle (if
one is included with your pressure washer) before installing,
changing, or adjusting accessories. For cold water use only.
Save these instructions. Refer to them frequently and use
them to instruct other users. If you loan someone this tool,
loan them these instructions also.
PRODUCT SPECIFICATIONS
Connections ..................................1/4 in. Quick Connect Plug
Deck Width ...................................................................... 11 in.
Maximum Pressure ........................................... up to 2,000 psi
Maximum Water Flow ..................................................1.4 gpm
Maximum Inlet Water Temperature .................................104°F
INSTALLING THE SURFACE CLEANER ON
THE SPRAY WAND
See Figure 1.
n Pull back the quick-connect collar on the pressure washer
spray wand.
n Insert the surface cleaner inlet plug into the spray wand quick
connect coupler.
n Push the collar forward so that the surface cleaner inlet plug is
secured properly. Check to see that the connection is secure.
WARNING:
To reduce the risk of injection or injury, only use the surface
cleaner on flat, horizontal surfaces. Never lift the surface
cleaner from the cleaning surface while operating the pres-
sure washer.
USING THE SURFACE CLEANER
See Figure 2.
WARNING:
Do not reach hands or feet under cleaning deck. Contact
with the spinning nozzles or spray bar can result in a fluid
injection or other serious personal injury.
INLET
PLUG
n Once the surface cleaner is installed, connect the hose to
the pressure washer as described in your pressure washer
manual.
n Start the pressure washer as described in your pressure
washer manual.
n Walk slowly behind the cleaning deck, cleaning as you go.
NOTE: If striping or swirling occurs, slow your pace. If strip-
ing or swirling continues, the surface cleaner nozzle(s) may
be clogged. See Nozzle Maintenance for how to clean the
nozzles.
QUICK CONNECT
COUPLER
Fig. 1
Fig. 2