PowerFit PF31015A Manual De Instrucciones

ROTARY BRUSH
PF31015A
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator's manual for their pressure washer
before using this accessory. Always wear eye protec-
tion. Risk of fluid injections; do not point at people, pets,
electrical devices, or the unit itself. Turn off the pressure
washer before changing or adjusting accessories. For
cold water use only.
PACKING LIST
Rotary Brush
1/4 in. Quick Connect Adaptor
APPLICATIONS
You may use this product for the purposes listed below:
 Rotary brush can be used for cleaning siding, polished
and painted metal surfaces, outdoor furniture fabrics,
plastics, fiberglass, glass, and vehicles.
 This product is not for commercial use.
INSTALLING THE ROTARY BRUSH
See Figure 1.
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Disconnect the high pressure hose from the trigger
handle.
 Install the rotary brush on the end of the trigger handle
or spray wand. If needed, install one of the adaptors
provided by fitting the threaded end of the adaptor over
the threaded end of the rotary brush handle.
 Reconnect trigger handle to high pressure hose.
WARNING:
To reduce the risk of injury or property damage, spray
the pressure stream in a safe direction to ensure proper
connection of all accessories before starting any clean-
ing project.
ADDING CLEANING SOLUTION TO BRUSH
See Figure 2.
Use only detergents designed for pressure washers and
approved for your cleaning application by the detergent
manufacturer. Do not use house hold detergents, acids,
alkalines, bleaches, solvents, flam mable material, or indus-
trial grade solutions. Many detergents require mixing prior to
use. Prepare cleaning solution as instructed on the solution
bottle. ALWAYS test detergents first in an area that is hidden.
 Open cap on back of brush.
 Pour cleaning solution into brush tank, using a funnel if
necessary.
 Replace cap on brush and secure.
TRIGGER
HANDLE
OR SPRAY
WAND
1/4 IN. QUICK
CONNECT ADAPTER
TRIGGER
HANDLE
ROTARY OR SPRAY
BRUSH
WAND
DETERGENT
DIAL
 Rotate detergent dial as desired to increase or decrease
amount of cleaning solution being dispensed.
 When finished, drain any remaining cleaning solution from
the brush and rinse brush clean before storing.
CAUTION:
Dirt and debris can damage delicate surfaces. Thoroughly
rinse the brush before use and continue to do so at
regular intervals during use. Thoroughly clean the brush
after use. Allow to dry and always store brush without
bending the bristles.
ROTARY BRUSH
CLEANING
SOLUTION
CAP
Fig. 1
Fig. 2