Idiomas disponibles
Idiomas disponibles
REAR PANEL
1.- DC 12V: port for connecting the AC-DC power adapter.
2.- DP IN: DisplayPort input port for connecting the DP video signal.
3.- HDMI IN: Type-A female HDMI port for connecting the HDMI video signal.
4.- 10G LAN: RJ45 port to connect directly to the RX or a network switch via a CATx cable.
5.- IR IN: 3.5 mm jack to connect an infrared receiver for infrared routing control.
6.- IR OUT: 3.5 mm jack to connect an infrared emitter for infrared routing control.
7.- RS232: euroblock for RS232 routing control Supports single-broadcast and point-to-multipoint
transmission settings.
8.- AUDIO IN: 3.5 mm jack for connecting an audio source.
9.- ETHERNET: RJ45 port to connect control devices (such as PC) for system control via software and
passage through Ethernet. The PC can also be connected indirectly via switch.
RECEIVER
FRONT PANEL
1.- POWER LED: the LED lights up red when the device is on.
2.- LINK LED: The LED indicates if Ethernet packets are received. It also indicates whether FPGA SERDES
can detect a valid signal.
- LED off: packets are not received and RX SERDES is not linked.
- LED blinking: packets are received and RX SERDES is linked.
- LED steady: packets are not received and RX SERDES is linked.
3.- HDMI LED: LED lights green when HDMI video is output.
- 3 -
EN
EN
