Connecting To Measuring Device; Connecting To The Circuit To Be Measured - Gossen MetraWatt METRAFLEX 300M Manual De Instrucciones

______________________________________________________________
4.2

CONNECTING TO MEASURING DEVICE

Read safety section of instructions before operating
this product.
METRAFLEX 300M: Plug the output cable of the current sensor
into the voltage measuring input terminals of the multimeter
(black to GND, red to V) and switch it to V AC.
4.3 CONNECTING TO THE CIRCUIT TO BE
MEASURED
It is strongly recommended to de-energize the circuits to
be measured
installation. If it is necessary to make connections on
energized circuits they must be made by qualified and
authorized personnel only observing the required safety
precautions.
Never apply the probe around bare conductors with
voltage levels over 1000V (CAT III) or 600V (CAT IV) to
ground.
Always connect electronics unit to measuring device
before installing the flexible measuring head.
Open the probe coupling and slip the measuring head over the
conductor carrying the current to be measured.
Close the probe coupling such that it visibly and audibly snaps
into place.
_______________________________________________________________
when making connections to the
11