Idiomas disponibles
Idiomas disponibles
POWER SUPPLY AND TURN-ON-CONNECTION
ATTENTION: Before you start with the installation, disconnect the ground connection from the ve-
hicle's battery in order to prevent short circuits.
The power wiring which is usually installed in on-board car networks is not sufficient for a power amplifier's
demands. Make sure that the power wires to GND and to the +12 V terminal has been sufficiently specified.
First connect the GND terminal [ 6 ] of the amplifier to an appropriate ground connection at the chassis. To
ensure a good connection, residue dirt and dust from the connection point. A loose connection may cause
malfunctions or interferences noise and distortion.
Then connect the +12 V terminal [ 4 ] of the amplifier with the battery by using an appropriate cable including
an in-line fuse. This fuse [ 2 ] should be located very close to the battery [ 1 ]; for safety reasons not more than
30 cm away. Only insert the fuse when the installation, including the connection of the loudspeakers, has been
accomplished.
Then connect the remote turn-on-wire [ 3 ] from the head unit with the amplifier's REM terminal [ 5 ]. A cable
with a cross-section of 0.5 mm
If the device fuse [ FUSE ] is defective, it must be replaced with an equivalent one.
PHASE
LOW
PASS
POWER
0°
180°
50Hz 150Hz
PROTECTION
OFF
ON
AUTO TURN ON
1
–
is adequate.
2
BASS
LEVEL
BOOST
INPUT
0dB
12dB
MIN
MAX
GP1000
ACTIVE SUBWOOFER SYSTEM
2
3
LOW LEVEL
INPUT
REMOTE
HI LEVEL INPUT
L+
L–
R+
R–
POWER
R
L
FUSE
4
5
GND
REM
+12V
6
9
