Idiomas disponibles
Idiomas disponibles
To replace a band on the Drum Sander, loosen the
screw without removing it to contract the drum
then slide the old band off. Slide the new sanding
band on and then expand the drum by tightening
the screw once again.
Service
!
NO USER SERVICEABLE PARTS
WARNING
INSIDE. Preventive mainte-
nance performed by unauthorized personnel may
result in misplacing of internal wires and compo-
nents which could cause serious hazard. We
recommend that all tool service be performed by a
Dremel Service Facility.
D.C. motors
The motor in your tool has been engineered for
many hours of dependable service. To maintain peak
efficiency of the motor, we recommend it be exam-
ined every six months. Only a genuine Dremel
replacement motor specially designed for your tool
should be used.
!
WARNING
nents are assembled to accessory shank and that
the drum is sufficiently expanded to secure the
band during use. If sanding band is loose on the
drum during operation it may "fly" off and strike
you or bystanders.
Maintenance
Cleaning
!
WARNING
before cleaning. The tool may be cleaned most
effectively with compressed dry air. Always wear
safety goggles when cleaning tools with com-
pressed air.
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not attempt to
clean by inserting pointed objects through opening.
!
CAUTION
Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and house-
hold detergents that contain ammonia.
Page 15
Before each use, check to
make certain that all compo-
To avoid accidents, always dis-
connect battery pack from tool
Certain cleaning agents and
solvents damage plastic parts.
