Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ENGINE
LUBRiCATiON
Use only high quality detergent oil rated
with API service classification
SG-SL.
Select the oil's SAE viscosity grade
according
to your expected operating
temperature.
SAE VISCOSITY GRADES
F
-20
0
30
32
40
60
80
100
C
-30
-20
-10
0
1'0
20
30
40
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
NOTE: Although
multi-viscosity
oils
(5W30, 10W30 etc.)improve
starting in
cold weather, these multi-viscosity
oils will
result in increased oil consumption
when
used above 32°F. Check your engine oil
level more frequently to avoid possible
engine damage from running low on oil.
Change the oi! after every 25 hours of
operation or at least once a year if the unit
is not used for 25 hours in one year.
Check the crankcase oi! level before
starting the engine and after each five (5)
hours of continuous
use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE:
Before tipping trimmer to drain oil,
drain fuel tank by running engine until fuel
tank is empty.
1. Disconnect
spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip trimmer on its side as shown and
drain oil into a suitable container.
Rock
trimmer back and forth to remove any
oil trapped inside of engine.
Container
4. Wipe off any spilled oil from trimmer or
side of engine.
5. Fill engine with oil (See "ADD OIL" in
the Operation
section of this manual).
11
6. Replace engine oil cap.
7. Reconnect spark plug wire to spark
plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter cartridge every 100
hours of operation or every season, which-
ever occurs first. Service air cleaner more
often under dusty conditions.
TO CLEAN AIR FILTER
1. Loosen screw and tilt cover to remove.
2. Carefully remove cartridge.
3. Clean by gently tapping on a flat sur-
face. If very dirty, replace cartridge.
ACAUTION:
Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge. They may cause deterioration
of the cartridge. Do not oil cartridge.
Do
not use pressurized
air to clean or dry
cartridge.
4. Install cartridge, then replace cover
making sure the tabs are aligned with
the slots in the back plate. Fasten
screw securely.
Back plate
Cartridge
Slot
Cover
Cover
tab
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, whichever
occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT
SPECIFIC-
ATIONS" section of this manual.
CLEANING
iMPORTANT:
For best performance,
keep
trimmer free of built-up grass and trash.
Clean the underside of your trimmer after
each use.
Tabla de contenido
