Switching On/Off; Replacing Blades - HAIRCUT PROFESSIONAL TH35 Manual De Utilización

PROFESSIONAL CORDLESS HAIR CLIPPERS
EN
3.2. Operation
When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 5).

3.2.1. Switching on/off

 Switch the clippers on by pressing the On/Off button (Fig. 1-B). The button lights
up.
 To stop the clippers, press the On/Off button again (Fig. 1-B). The button goes
out.
 When the clippers are not in use, it is advisable to clip the cutter cover (Fig. 1-
O) onto the blades.
3.2.2. Use with or without electrical lead
 With a new, fully charged battery, the clippers can be used without the power
lead for about 120 minutes.
 Before the end of the autonomy period, the charge light flashes.
Charge the battery, refer to § 3.1.
 The clippers can be used with the electrical lead. For this, connect the cable to
the clippers (Fig. 3a) and connect the power pack (Fig. 1-L) to a mains power
socket.
3.3. Adjusting the cutting height with the lever
The cutting height can be adjusted during use of the clippers, with the adjusting lever
(Fig. 1-C):
 Push the lever upwards to reduce the cutting height.
 Push the lever downwards to increase the cutting height.
3.4. Using the comb attachments
 The clippers
(Fig. 1, refs. E-J).
 Place the comb attachment on the blades and clip in at the rear. When the comb
attachment is correctly fixed, it is immobilized.

3.5. Replacing blades

 Switch the clippers off and unplug the unit from the mains power supply.
 Take the screws out of the blades (Fig. 4) and remove the upper and lower
cutters.
must be switched off. Select
23
a comb attachment