Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Battery
1. Insert the battery on the groove and slip it all the way
until you hear a "click" noise from the lock/unlock
button. At this point, the battery is locked in place;
2. To remove the battery, press the lock/unlock button
and pull it out.
Use ITOOLS' 18V lithium-ion batteries.
Charging the battery
1. Fit the battery in the charger;
2. Plug the charger into the socket and let it charge.
Sometimes at the end of charging, both the battery and
the charger can be hot, which does not mean they
malfunction.
Let the battery cool down before putting it in the combi
drill.
Changing and inserting drills and bits
The combi drill can be used both to bore holes and to
tighten/loosen bolts. For this purpose, drills and bits are
used.
Never insert or change the drills and bits while the
combi drill is running. Always switch it off the l before
doing this.
1. Set the forward/reverse button to the middle position
to lock the "ON/OFF" switch;
2. Hold the combi drill by the handle with one hand and
turn the quick-change clockwise until the drill or bit
can be inserted;
3. Insert the drills or bit into the chuck;
4. Hold the combi drill by the handle with one hand and
turn the quick-change chuck counterclockwise until
the drill or bit is properly fastened in the chuck jaws.
When using screwdriving bits, always use a magnetic bit
holder.
30
OPERATING INSTRUCTIONS
The combi drill can be used both to bore holes and to
tighten/loosen screws/bolts. For this purpose, drills and
bits are used.
When operating the combi drill, you must consider
some use procedures:
▪ When working on small or loose workpieces, use
clamping devices to fix workpieces securely and
stably;
▪ Do not apply excessive pressure on the drill against
the workpiece/object. If the speed drops abruptly,
reduce the pressure applied to the combi drill
immediately;
▪ When the bit or drill gets jammed, switch off the
power tool immediately. Avoid the high reaction
torques that cause kickback;
▪ Never put the power tool down before the accessory
has completely stopped;
▪ Switch off the combi drill immediately if any of the
following problems occur:
- Grease leakage through the ventilation slots;
- Damage to the combi drill housing;
- Damage to the "ON/OFF" switch;
- If you sense smoke or burning smell.
Start and stop
1. Press the "ON/OFF" switch and touch the drill or the
bit against the surface or screw;
2. To increase and decrease the rotation speed, press
the "ON/OFF" switch fully or smoothly respectively.
The maximum speed is reached with the switch
pressed down completely;
3. To switch off the combi drill, release the "ON/OFF"
switch.
While the combi drill is running, the LED light will
illuminate.
