Husqvarna CTH126 Manual De Las Instrucciones página 25

Ocultar thumbs Ver también para CTH126:
TO ASSEMBLE BAGGER
Unfold bag and stand right side up.
Feed front bagger frame (1) up through fabric loops at each
side of bagger.
Snap bottom of front bagger frame (1) into snap feature at
front of bagger bottom.
Slide bagger fabric loop (2) segments at the ends of bag
onto top bagger frame tubing.
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the front of
top frame.
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through holes
at top of the front bagger frame and thread into nuts inside
the tubing of top bagger frame.
1
Uninstall (¼"-20) locknuts (4) at bottom of front bagger frame.
Unfold cross braces (5) and attach to carriage bolts at bottom
corners of front bagger frame.
Reinstall (¼"-20) locknuts (4) and tighten until fully seated.
5
Remove clevis pin (6) and retainer spring (7) from bagger
handle (8).
Slide bagger handle (8) down through bagger cover and
frame upper weldment holes.
Reinstall clevis pin (6) through hole at bottom of bagger
handle and slide retainer spring (7) into hole at the end of
the clevis pin until it locks into place.
7
3
4
8
6
TO ADJUST HANGER BRACKETS
The tractor comes from the factory with the bagger pivot bracket
preset in a fixed position. If necessary, this position can be adjusted
to maintain a consistent gap (A) between the fender and the bag-
ger assembly top. An ideal gap is approximately 0.2" (5.1mm).
NOTE: As desired, the hanger bracket on either side can be
adjusted in this manner.
Remove bagger assembly.
NOTE: ADJUST ONLY ONE SIDE AT A TIME.
VERTICAL ADJUSTMENT
Loosen nuts on carriage bolts (1) to allow the adjustment plate
(2) to slide up or down. Move as needed. Retighten nuts
securely, locking the adjustment plate in its new position.
Repeat on opposite side.
2
HORIZONTAL ADJUSTMENT
Loosen nuts on carriage bolts (3) to allow the adjustment plate
(4) to slide forward or rearwards. Move as needed. Retighten
nuts securely, locking the adjustment plate in its new position.
Repeat on opposite side.
A
Readjust if necessary.
TO INSTALL BAGGER SPRING LATCH
The bagger spring latches are located on the back plate (1), one
in each of the bottom corners.
Before installing, tractor engine must be shut off and parking
brake engaged.
Install each bagger spring latch with the loop end (2) down
and facing towards the bagger assembly.
Place the mounting bolt (3) through the curved end of the
bagger spring latch, through the back plate, and secure with
nut (4) as shown. Tighten firmly.
25
1
2
3
2
2
4
3
1
4
loading