Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Electrical
Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed to
prevent motor failure
and/or
electrical shock.
Check motor safety filter occasionally
and clean when dirty,
1. Unplug cord
from wall out-
let and remove
bag°
2. Pull out
safety filter as
shown.
3. Wash filter in warm soapy water, rinse,
then dry_ Do not clean in dishwasher
or
install
while damp,
4. Snap filter
back into canis-
ter.
5. Insert bag.
This vacuum has a thermal protector which automatically
trips to protect the vacuum from
overheating.
The thermal protector turns the motor off automatically
to allow the motor to cool
in order to prevent possible damage to the vacuum.
To reset: Turn off and unplug the vacuum from the outlet to allow the vacuum to cool, Check
for and remove any clogs. Also check and replace
any clogged
filters, Wait
approximately
50 minutes
and plug the vacuum
in and turn back on to see if the thermal
protector
has reset, In some cases, the unit may suddenly
restart.
DO NOT leave
unattended,
1, Unplug cord from wall outlet. Do not drip
water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent
and water, then wrung dry.
Wipe dry after cleaning.
3. To reduce static electricity
and dust build-
up, wipe outer surface of cleaner and
attachments.
DO NOT USE ATTACHMENTS
IF THEY
ARE WET.
!
•
CAUTION
........................
Attachments
used in dirty areas,
such as under a refrigerator,
should
not be used on other surfaces
until
they are washed.They
could leave
marks.
11
Tabla de contenido
