Idiomas disponibles
Idiomas disponibles
SYMBOLOGY
Volts
Direct Current
Amps
Hertz
Read operator's manual
Presence of important operating
instructions.
CAUTION
Federal Communications Commission
Approval Mark for Mexico
UL Listing for Canada and U.S.
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
The MILWAUKEE jobsite radio can be powered by
MILWAUKEE M18™ Li-Ion battery packs or provided
adapter. When plugged into a wall outlet, the bat-
tery bay will not charge MILWAUKEE M18™ Li-Ion
battery packs.
Low Battery Indicator
When the radio is powered by a battery pack and
its charge falls below 10%, the low battery indicator
is displayed.
USB-C Power Outlet
This outlet can be used to charge a USB device that
uses less than 3 A of DC electrical current. The USB-
C outlet will supply power when the battery pack is
inserted and the radio is ON, or anytime the radio is
plugged into the wall adapter.
NOTE: Any device that uses more than 3 A of DC
electrical current will trip a self-resetting function and
disable the output.
Risk of electric shock.
Power
Changing Back-up Batteries
Batteries may leak chemicals or
WARNING
may explode if used incorrectly.
The following care should be taken to prevent
such an incident:
•Make sure the positive (+) and negative (-) bat-
tery terminals are positioned correctly.
•Do not mix new and old batteries together, or
mix different types of batteries.
•Do not try to recharge non-rechargeable batteries.
•If chemicals from the batteries come in contact
with your skin, wash them off immediately with
water. If chemicals leak onto the radio, clean the
radio completely.
To hold station presets and clock time when the bat-
tery pack is removed, 2 AAA batteries are required.
1. Remove battery pack and unplug radio.
2. Remove the screw and battery cover.
3. Insert two (2) AAA batteries according to
matching positive (+) and negative (-) marks.
4. Replace the battery cover and screw.
OPERATION
To reduce the risk of fire or electric
WARNING
shock, do not expose this radio to
rain or moisture.
Turning On/Off and Controlling Volume
Plug the cord into an appropriate AC outlet or install
a battery pack.
Press the power button
off. The radio station (frequency) is displayed. To
display the time, press the CLOCK button. Volume
is restored to the last setting.
NOTE: When the radio is running on battery power,
the display will dim after 5 minutes to reduce power
use.
Press the volume buttons to increase or decrease
the volume.
Setting the Clock
1. Press and hold the CLOCK button until the hour
begins to flash.
2. Use the
buttons to change the hour.
3. Press the CLOCK button again. Use the
change the minutes.
4. Press the CLOCK button again to save.
EQ Adjustment
To manually adjust the Bass/Treble sound, press
the EQ button. Set the bass sound by using the
buttons. Press the EQ button again to set the treble
sound by using the
Selecting Band
Push the AM/FM button to select AM or FM.
Tuning (Seeking and Scanning)
Press and hold the
the band. When a station is found, the SEEK will
stop. Use the SCAN button to continue through the
stations, pausing at each.
4
to turn the radio on and
buttons.
buttons to SEEK through
to
