Idiomas disponibles
Idiomas disponibles
EN
•
When the forward and reverse rotation button R is
pressed, the flexible shaft stretches in the opposite
direction.
3. When the operating handle is in the N neutral position,
the flexible shaft stops stretching no matter in forward or
reverse rotation
15
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Do not use strong solvents or detergents on the plastic
housing or components.
16
REPLACE THE FLEXIBLE
SHAFT
M3 screw
•
Please check if the battery pack is unplugged before
replacing it！
•
This pipe dredger provides a quick flexible shaft
replacement device.
1. Place the operating handle in the N position;
2. Take out the flexible shaft to expose the connector;
3. Unscrew the M3 set screws with an Allen wrench and
remove the unwanted flexible shaft;
4. Insert the new flexible shaft into the connector, align the
screw holes, and tighten the M3 set screws again;
5. Push the flexible shaft manually to the inside of the drum.
NOTE
WARNING
WARNING
Connector
WARNING
English
•
Do not start the tool to retract the flexible shaft, because
the exposed flexible shaft can lead to unpredictable
personal injury, tool damage, damage to indoor objects,
fire, electric shock and other dangerous situations.
•
If the flexible shaft cannot be replaced normally, please
send it to the designated service center for repair.
17
STORAGE AND
MAINTENANCE OF THE
MACHINE
Before inspection and maintenance, please switch off tool
power and take off the battery pack!
1. After each use, rotate manually the drum until the
waterproof plug is exposed out of the housing and
remove the waterproof plug with allen wrench. Erect
tools with head down so that liquid inside the drum will
drain out and reinstall the waterproof plug.
Do remember to take off the wrench in case of tossing out
when started next time, causing personal injuries.
1. Please clean the flexible shaft and drum carefully. If it is
not to be used for a long time, please apply butter on the
surface of the flexible shaft to prevent rust.
18
TROUBLESHOOTING
Problem
The motor shuts
down whilst work-
ing.
The machine
smokes during op-
eration.
10
WARNING
NOTE
NOTE
Possible cause
Solution
Make sure that
The battery pack is
you tighlty instal-
not installed tight-
led the battery
ly.
pack in the ma-
chine.
The battery pack is
Charge the battery
out of power.
pack.
The machine has
Do not use the ma-
damage.
chine and speak to
service center.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery.
3. Speak to serv-
ice center.
