Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Spray Technology
The spraying result depends crucially on how smooth and clean the surface before
spraying. Therefore, the surface must be pretreated and dust-free.
Not to be sprayed must be covered with tape and newspaper.
Cover screw or similar at the object being sprayed.
It is important to perform on cardboard or a similar surface spray sample to find the
right spray gun setting
FIG.8
FIG.6
FIG.7
Important: the open space of the spray area start and disruptions Avoid within the spray area.
Directional strength (Fig. 6) Hold the spray gun necessarily at equal distance of
about 5 -15 cm for the object being sprayed.
False (Fig. 7)
Tarke overspray, unevenly even surface quality.
Move the spray gun evenly across or up and down, depending on the pattern adjustment.
A uniform spray gun guide gives a uniform surface quality.
Clean as coating material buildup on the nozzle A and air cap B (Fig. 8) both parts
with solvents or water.
Work Stoppages
Decommissioning and cleaning
passes back into the container.
2 Unscrew the container. Remaining coating material in material tin back empty.
3 Containers and tubing with pre-cleaning brush.
Only use solvents with a flash point above 37.8ºC.
When a tube is not used, deposited solvent or water in addition to the container.
Therefore, the air is hoche ed current volume.
5 Repeat the above procedure is leaking at the nozzle clear solvent or water.
7 Then, empty the tank completely. Always keep container seal free of paint residue
and check for damage.
8 Clean spray gun and container exterior with a cloth soaked in solvent and water cloth.
9 Unscrew the nut, remove the air cap. Clean the air cap and nozzle with brush and
solvent or water.
Note:
Never clean the nozzle or air holes in the spray gun with sharp metal objects.
11
Tabla de contenido
