Anti-Calc System; Anti-Drip System - HAEGER Vapour Pro 2700 Instrucciones De Uso

English
Crease removal in vertical
 Set the temperature regulator between the (••) and (•••) settings and wait until the iron reaches temperature.
 Hang the garment on a hanger and place the iron some 10-20 cm away. Never iron a garment if somebody is wearing it at the
time.
 Press the super steam push button pausing for at least 5 seconds between each press.

Anti-Calc System

This iron has an innovative built-in anti-limescale system, consisting of a resin filter that retains the limescale substances from the
water, so these cannot reach the steam chamber of the soleplate, thus extending the life of the iron.
However, please note that the anti-limescale cartridge will not completely stop the natural process of limescale build-up.

Anti-Drip system

The iron incorporates an anti-drip system that prevents the iron from dripping, even when it is switched off.
Self-Cleaning
The function of self clean is to clean the soleplate after using the iron for approximately 2 months.
1. Fill the water container up to the marking MAX.
2. Insert the plug into the power socket.
3. Set the temperature regulator to the position MAX (•••).
4. When the iron warm up till the control light cuts off and lights up again, unplug the iron.
5. Hold the iron horizontally over a trap vessel.
6. Press the Self-Clean button and hold it in this position. Now steam and boiling water will start emerging from the steam escape
holes at the gilding sole. Any dirt, if present, will get washed out.
7. Release the Self-Clean button as soon as the water in the water container is used up.
6 Instructions for use