Mounting The Device - HQ-Power VDPL300MF Manual Del Usuario

• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.

4. Mounting the Device

• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
The VDPL300MF can be used as a stand-alone device or in a master/slave configuration.
• Master/Slave Mode
Connect all units through the XLR connections (male = input, female = output) using standard XLR cables. The first
unit in the chain should be the master device. Choose the desired mode on the master device and set all other
devices into slave mode (press MODE until SLAV is displayed).
• Program Mode
Select your pattern, speed and flash rate. Press MODE until PR.XX is displayed. Select one of the 15 programs with
UP/DOWN and confirm with SET UP. SP.XX is now displayed. Adjust the speed from 1 ~ 99 with UP/DOWN. Confirm
with SET UP. FS.XX is now displayed. Adjust the flash rate from 1 ~ 99 with UP/DOWN. Confirm with SET UP.
• Auto Mode
Press MODE until auto is displayed. The device will run through the 15 built-in programs.
• Sound-Controlled Mode
The device will react to the surrounding noises and chase through the different colours. Press MODE until SU.XX is
displayed. Press UP/DOWN and adjust the sound sensitivity between 01 ~ 10 (from low to high).
VDPL300MF
4 HQPOWER