Adjust The Cutting Depth; Adjust The Cutting Width; Operate The Machine; Maintenance - Powerworks CRG303 Manual Del Operador

EN
8.3

ADJUST THE CUTTING DEPTH

1. Loosen the depth adjustment lever.
2. Raise or lower the base until the depth scale
reaches the required cutting depth.
3. Tighten the depth adjustment lever.
8.4

ADJUST THE CUTTING WIDTH

1. Loosen the depth lock knob to move the edge guide
to the necessary width.
2. Tighten the depth lock knob after adjustment.
8.5

OPERATE THE MACHINE

2
1
1
@ 0°
@ 45°
2
English
Kickback occurs when the blade stalls quickly and the
machine is driven back to you. A step which pinches the
blade in the wood can cuase blade stalling.
To prevent kickback, release switch trigger
immediately if the blade stalls.
1. Keep the blade at the correct depth position.
2. Examine the workpiece for nails before you cut. Do
not saw into a nail.
3. Make straight cuts. Use a straight edge guide when
rip cutting. This helps prevent you twist the blade.
4. Use clean, sharp, and correctly set blades. Do not
make cuts with blunt blades.
5. Support the workpiece correctly before you begin a
cut.
6. Use stable pressure when you make a cut. Do not
force a cut.
7. Do not cut warped or wet lumber.
8. Hold the saw tightly with the two hands and keep
your body in a balanced position to against the
forces if kickback occurs.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
10
WARNING
CAUTION