Scotts S20500 Manual Del Operador página 16

NOTE: Do not use dirty, used, or otherwise
contaminated oils. Damage may occur to the
bar or chain.
 Carefully pour the bar and chain oil into the tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
 Depress the oil tank cap several times to pump
the oil to the chain before starting the saw.
 Depress the oil tank cap every 20-30 seconds
while cutting to keep the chain lubricated.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
STARTING AND STOPPING THE CHAIN
SAW
See Figure 8.
WARNING:
Keep body to the left of the chain line. Never
straddle the saw or chain, or lean over past the
chain line.
Starting the chain saw:
 Place the chain saw on a flat bare surface and
make sure no objects or obstructions are in
immediate vicinity which could come in contact
with the bar and chain.
 Press and hold the lock-out button. This makes
the switch trigger operational.
 Press and hold the switch trigger, release the
lock-out button and continue to squeeze the
switch trigger for continued operation.
Stopping the chain saw:
 Release the switch trigger to stop the chain saw.
 Upon release of the switch trigger, the lock-out
button will be automatically reset to the lock
position.
OPERATION
LOCK-OUT
BUTTON
PREPARATION FOR CUTTING
PROPER GRIP ON HANDLES
See Figures 9 - 11.
Refer to Important Safety Instructions earlier in this
manual for appropriate safety equipment.
 Wear non-slip gloves for maximum grip and
protection.
 Hold the saw firmly with both hands. Always
keep your left hand on the front handle and your
right hand on the rear handle so that your body
is to the left of the chain line.
16 — English
SWITCH
TRIGGER
SWITCH
TRIGGER
LOCK-OUT
BUTTON
Fig. 8