Mx Onda MX-AS2060 ERP II Manual De Instrucciones página 64

Warning: Before cleaning or handling of the vacuum cleaner make sure it is
unplugged from the mains supply.
Dustbin cleaning
Unplug the vacuum cleaner from the mains, then hold the tank by the
handle, press the tank removal button (L) and pull it upwards (Fig. 4).
To empty the tank press the opening clip (
will open. Take care to place the container on top of the garbage can or a
bag before opening the lid.
Once the tank has been emptied, open the upper lid of the tank by slightly
pulling the tab outwards (Fig. 6) and remove the particle filter (Fig. 7).
Fig. 4
Wash the particle filter with plenty of water, clean the inside of the tank with
a slightly damp cloth. Never use abrasive products or products that contain
solvents. Then dry the inside of the tank with a dry cloth. The particle filter
must be left to dry on its own, do not use a hair dryer or heater as this will
damage the filter.
Once the tank and particle filter are clean and completely dry, place them
as described below:
a. Close the lower lid of the reservoir, a "click" will indicate that it is
properly closed.
b. Insert the particle filter into the passenger compartment located in the
upper part of the tank so that the rubber ring of the particle filter fits
correctly on the edge of the multi-cyclone filter, then press lightly with
your fingers on the rubber ring to check that It is perfectly coupled.
Finally, close the lid and a "click" will indicate that the lid is properly
closed.
c. Attach the tank (fully assembled) to the main body of the vacuum
cleaner, and then push the tank towards the vacuum cleaner, when
you hear a "click" it will be the indication that the tank is correctly
coupled to the main body of the vacuum cleaner.
Fig. 5
9
) of the tank lid (Fig. 5) and it
Fig. 6 Fig. 7