Blaupunkt BP 1003 Manual De Instrucciones página 7

Idiomas disponibles

Idiomas disponibles

INTRODUCTION
Before using your new heater, please carefully read through the following instructions. KEEP
THIS BOOKLET IN A SAFE PLACE SO THAT YOU MAY CONSULT IT LATER.
After removing the packaging, make sure that the appliance is in good condition.
The packaging materials may contain plastic, nails etc., which may be hazardous and therefore
should not be left within the reach of children.
IMPORTANT SAFETY INFORMATION
Avoid installation behind a door.
Use only the voltage specified on the rating plate of the heater.
Do not cover or restrict airflow to the inlet or exhaust grilles in any manner as the appliance
may overheat and become a fire risk (for Heaters).
Do not cover grilles, block entry or exhaust of airflow by placing appliance against any surface.
Keep all objects at least 1 metre from the front, sides and rear of the appliance. With exception
of appliances designed for wall-mounting, maintain a 1 metre gap from the rear of the unit as
well.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR POSITIONED CLOSE TO CURTAINS OR
OTHER COMBUSTIBLE MATERIALS
Do not place appliance close to a radiant heat source.
Do not operate in areas where gasoline, paint or other flammable liquids are used or stored.
This appliance heats up when in use. To avoid burns, do not let bare skin touch hot surfaces.
Switch off and use handles where provided when moving.
Do not use the appliance to dry clothes.
Do not leave the appliance unattended whilst in use.
Do not insert or allow foreign objects enter any ventilation or exhaust opening, as this may
cause an electric shock, fire or damage to the appliance.
Do not immerse in liquid or allow liquid to run into the interior of the appliance, as this could
create an electrical shock hazard.
Do not use this appliance on a wet surface, or where it can fall or be pushed into water.
Do not reach for an appliance that has fallen into water. Switch off at supply and unplug
immediately.
Do not operate any appliance with a damaged cord, plug or after the appliance malfunction
or has been dropped or damaged in any manner. Return to a qualified electrical person for
examination, electrical or mechanical adjustment, service or repair before further use.
Do not operate appliance with wet hands.
This appliance is intended for household use only and not for commercial or industrial use.
Use this appliance only as described in this manual. Any other use is not recommended by the
manufacturer and may cause fire, electric shock or injury.
A common cause of overheating is deposits of dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging the appliance and vacuum-cleaning air vents
and grilles, where available.
Do not use this appliance in a window as rain may cause electric shock.
Do not use abrasive cleaning products on this appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always remove plug from the mains supply before cleaning.
Do not connect the appliance to the mains source until it has been installed in its final location
EN
7
loading