Step 27
Step
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (T) to the SMALL UPRIGHT (F) as
å
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB (28K) to the DOOR (T). Use a GOLD 1"
å
MACHINE SCREW (50S).
Insert a DOOR STOP (4I) into the hole in the UPRIGHT (E).
å
See the next step for DOOR adjustments.
å
Page 32
Stop
Mounting
screw
F
T
E
GOLD 1" MACHINE SCREW
(1 used for the KNOB)
420410
Hinge
4I
28K
50S
www.sauder.com/services
